Worker fell 10 feet from a rooftop. Part 14.1(1)(a) of the Manitoba Regulation states that fall protection must be implemented “…where there is a risk of a worker falling a vertical distance of 3m or more”. This could include guardrails to prevent a fall, or a harness and lanyard attached to an anchor point to avoid impacting the ground below.

Virtual Toolbox Talk - Fall Protection
Classroom Training - Working at Heights

Workers demolishing an interior structure for renovation released a suspected asbestos-containing material. Asbestos-containing materials (ACMs) must be inventoried in accordance with Regulation Part 37.3, and records must be retained for 30 years. When ACMs are identified, a plan must be developed to safely contain and remove them.

Toolbox Talk - Asbestos
Online Training - Asbestos Awareness

Worker fell 10-12 ft. injuring both legs. Proper training on safe work practices and procedures will help reduce the frequency and severity of incidents. Task-specific training should follow the outlined practice or procedure, along with a practical evaluation to ensure worker understanding of the training.

Safe Job Procedure - Working at Height
Classroom Training - Working at Heights

Worker fell approximately 8.5 ft. through a temporary opening. Temporary floor openings must be protected by either securely covering them with a minimum 3/4'' plywood marked 'HOLE,' or by installing a guardrail system to prevent workers from stepping in or tools and equipment from falling through.

An object fell from a concrete pump truck, striking a worker in the head. The Manitoba Regulation Part 6.11 outlines the requirement for hard hats to be worn on all construction projects where there is a risk of overhead or side lateral impact to a worker’s head.

Toolbox Talk - Head Protection
Online Training - Personal Protective Equipment: The Right Choice!

Worker made contact with live electrical equipment. Part 38.14 of the Regulation states that all electrical equipment must be locked out and de-energized before work begins. The equipment should be tested to ensure that no residual energy exists.

Toolbox Talk - Lockout/Tagout
Online Training - Lockout/Tagout: Make No Mistake

Worker was hit by a truck travelling in reverse. The Manitoba Regulation Part 20.7 states that an employer must ensure a designated worker is acting as a signal person when powered mobile equipment travels in reverse on all construction sites. 

Toolbox Talk - Powered Mobile Equipment
Classroom Training - Hazard Identification and Risk Control.

Worker fell from the third rung of a ladder while descending. 3-point contact while climbing or descending a ladder is vital to worker safety. Tools and equipment should not be in a worker’s hands at these times.

Virtual Toolbox Talk - Ladders

Worker reached for a loose bolt on an A-frame component causing it fall on their hand. Overreaching on ladders or support structures can cause workers to struggle to do a task safely. Workers should remain between the frame rails of the ladder or structure for best stability.

Worker fell 27 ft. to the ground through a roof opening. Part 14.1(1)(a) of the Manitoba Regulation states that fall protection must be implemented “…where there is a risk of a worker falling a vertical distance of 3m or more”. A thorough hazard assessment or workplace inspection helps workers recognize the risks associated with their tasks.